Surface-mounted presence detector

04 July, 2013

CP Electroincs, presence detector, lighting control

CP Electronics’ EBDSPIR presence detector is now available as a surface-mounted version. It can be used for the automatic control of lighting, heating and ventilation. This versatile unit is self contained and easy to install via a back plate. it is also available as a flush-mounted unit for ceiling tiles.

This detector uses passive infra-red (PIR) to monitor the zone. It will switch on when occupancy is detected and off when the area is vacated following a preset time delay that can be adjusted between 10 s and 30 min.

If there is sufficient natural light, a built-in photocell will keep the lighting switched off. A manual on/off over-ride is available via an options infra-red handset.

There are no external control boxes, considerably reducing installation time.

For more information on this story, click here: July 2013, 164

Related links:

‘Red tape scrapping is welcome – but more policy changes are needed’

The CEO of heat pump manufacturer Aira UK has said the government’s new proposals to scrap planning red tape for the installation of heat pumps in the UK will be a big breakthrough for the industry and consumers – but more policy changes are needed.

New procurement rules for NHS suppliers

New procurement rules mean NHS suppliers will need to demonstrate their green credentials so the NHS can achieve its target of becoming net zero for directly-controlled emissions by 2040, with an ambition to reach an 80% reduction in its carbon emissions between 2028 to 2032.

Calendar

Submit event

Tweets by MBS_magazine

Surface-mounted presence detector

Related links:

Related articles: